Overall Objectives
Research Program
Application Domains
Software and Platforms
New Results
Partnerships and Cooperations
XML PDF e-pub
PDF e-Pub

Section: Research Program

Computational fluid mechanics: resolving versus modelling small scales of turbulence

A typical continuous solution of the Navier Stokes equations is governed by a spectrum of time and space scales. The broadness of that spectrum is directly controlled by the Reynolds number defined as the ratio between the inertial forces and the viscous forces. This number is quite helpful to determine if the flow is turbulent or not. In the former case, it indicates the range of scales of fluctuations that are present in the flow under study. Typically, for instance for the velocity field, the ratio between the largest scale (the integral length scale) to the smallest one (Kolmogorov scale) scales as Re3/4 per dimension. In addition, for internal flows, the viscous effects near the solid walls yield a scaling proportional to Re per dimension. The smallest scales may have a certain effect on the largest ones which implies that an accurate framework for the computation of flows must take into account all these scales. This can be achieved either by solving directly the Navier-Stokes equations (Direct numerical simulations or DNS) or by first applying a time filtering (Reynolds Average Navier-Stokes or RANS) or a spatial filtering operator to the Navier-Stokes equations (large-eddy simulations or LES). The new terms brought about by the filtering operator have to be modelled. From a computational point of view, the RANS approach is the less demanding, which explains why historically it has been the workhorse in both the academic and the industrial sectors. Although it has permitted quite a substantive progress in the understanding of various phenomena such as turbulent combustion or heat transfer, its inability to provide a time-dependent information has led to promote in the last decade the recourse to either LES or DNS. By simulating the large scale structures while modelling the smallest ones supposed to be more isotropic, LES proved to be quite a step through that permits to fully take advantage of the increasing power of computers to study complex flow configurations. In the same time, DNS was progressively applied to geometries of increasing complexity (channel flows, jets, turbulent premixed flames), and proved to be a formidable tool that permits (i) to improve our knowledge of turbulent flows and (ii) to test (i.e. validate or invalidate) and improve the numerous modelling hypotheses inherently associated to the RANS and LES approaches. From a numerical point of view, if the steady nature of the RANS equations allows to perform iterative convergence on finer and finer meshes, this is no longer possible for LES or DNS which are time-dependent. It is therefore necessary to develop high accuracy schemes in such frameworks. Considering that the Reynolds number in an engine combustion chamber is significantly larger than 10000, a direct numerical simulation of the whole flow domain is not conceivable on a routine basis but the simulation of generic flows which feature some of the phenomena present in a combustion chamber is accessible considering the recent progresses in High Performance Computing (HPC). Along these lines, our objective is to develop a DNS tool to simulate a jet in crossflow configuration which is the generic flow of an aeronautical combustion chamber as far as its effusion cooling is concerned.